Bishop Sound UK BP4k Power Amplifier 3000 w

Designed in the UK, the Bishop Sound BP4k includes a number of features to give the best performance for our speakers and most other passive speakers.Here are the key features:

• 2 x 1000 Watts RMS into 8 Ohms
• 2 x 1500 Watts RMS into 4 Ohms
• Only 5kg in total!
• Intelligent fans switch in and out dependent on the heat generation automatically to ensure cool running
• Limiters protect the BP4K from damage by moving to protect mode when THD is more than 0.5%
• Each of the 2 channels has an independent clip, protect and signal indication.
• Strong 1u rack ears for easy touring rack installation
• 2 x XLR balanced Neutrik analogue audio inputs
• 2 NL4 Neutrik speakON output connectors

For more details, help and advice please contact Bishop Sound

Protection:

• Soft Start
• DC
• Short Circuit
• Overload
• Distortion limiting
• Overheating
• VHF

Our service centre is fully equipped to give detailed advice on configuration and set-up. A complete user manual comes with every amplifier.

The Bishop Sound BP4k weighs 5kg and operates 2 channels. The BP4k delivers 2 x 1500w RMS at 4 ohms. This amp will not bridge.

Designed to run down to 200v at which point the amplifier will go into protect mode. As soon as the voltage is restored you will be able to use the amplifier again. This is important if you are running a power amplifier off a generator with an unstable power regulator.

Always use a power conditioner with this product for your safety and to ensure your expensive PA is protected. See Power Conditioners – BishopSound

1U amplifiers must be kept cool!  High-speed fans are built-in but the only source of airflow is from the front vents so it is of the utmost importance to check monthly and keep these clean and free from clogging up with dust and dirt.

• 2 x 1000 Watts RMS into 8 Ohms
• 2 x 1500 Watts RMS into 4 Ohms
• Intelligent fans switch in and out dependent on the heat generation automatically to ensure cool running
• Limiters protect the BP4K from damage by moving to protect mode when THD is more than 0.5%
• Each of the 2 channels has an independent clip, protect and signal indication.
• Strong 1u rack ears for easy touring rack installation
• 2 x XLR balanced Neutrik analogue audio inputs
• 2 NL4 Neutrik speakON output connectors
• Frequency response: 20Hz‰ÛÒ20kHz (0.5~-1.2dB)
• Total harmonic distortion: <0.05%
• Signal to noise ratio: >98dB
• Damping coefficient: >900 (100Hz)
• Resolution: >70dB
• Conversion rate: >20V/ë_s
• Input sensitivity: 1.0V
• Input impedance: 10kë©/20 kë©
• Voltage gain (8ë©) 39dB 40.3dB 42.0dB 43.0dB
• Amplifying circuit structure CLASS-D

Protection:

• Soft Start
• DC
• Short Circuit
• Overload
• Distortion limiting
• Overheating
• VHF

Connection Input section:

• Balanced input XLR female socket, balanced and connected XLR male socket
• Output section: NL4 type SPEAKON socket
• Indicator panel Lights: Power, signal UV, peak clipping,
• Front panel function: Power start switch, volume control knob, displays
• Rear panel function Stereo, the parallel selection switch
• Power supply: Removable standard power plug power cord AC220-240V/50Hz.å±10%
• Weight 5kg
• Product Dimensions 483x250x44